How To Install Hardie Board Siding Over Stucco

But if you want a look that echos stucco without all the hassles fiber cement siding is a better choice.

How to install hardie board siding over stucco.

While holding the strip in place on the stucco wall insert concrete screws through the holes and into the stucco using a hammer drill. If you love stucco nothing else will substitute. At the top of the window and door frames attach the siding strip to a strip from the next row up. Install james hardie siding the right way.

If you have traditional or hard coat stucco you need to fasten nailing boards every 16 inches on center onto the stucco wall. Cut the siding to fit around the sides of the window and door openings and drive nails into the furring strips to hold them in place right around the edge of the frame. Lap siding or the j channel used to install vinyl siding is attached directly to the furring strips. Replacing stucco with james hardie international s hardiplank siding on the exterior of your home dramatically changes the styling of the home.

Install the two together for extra strength. Even though most reputable contractors will never install siding over existing siding there are knuckleheads out there that will say you can do it and it s not a problem. Get a reliable james hardie siding contractor that stands behind their work to install your siding the right way. This allows us to nail the hardie boards and trims to the strapping which is a level and structural fastening surface.

Barry on painting hardie board siding a custom color before installation. A case study in how it can go horribly wrong. Pre drill holes in the furring strips about 8 inches apart. This video will outline the basics of installing james hardie s fiber cement products.

Unfortunately it isn t a good idea to try to install hardiplank siding over the top of surfaces that aren t flat and even. Any lower and you might see a few nail heads poking through the bottom of the next board any higher and your siding is likely to be loose and. Use 2 by 4 inch strips made from treated wood because stucco being a masonry product can absorb moisture and transfer it to the furring strips. Eric on installing siding over siding.

Each furring strip is attached to the stucco wall using a 16 inch center. Hardie plank siding has a nail line across the top of the board that is 1 down from the top and nails are supposed to fall between and 1 from the top of the board to give the best hold. Once the wall is furred out you need to fasten closed cell foam boards between them.