How To Install Standing Seam Siding

Pancake screws are applied to the nail strip of the standing seam panels.

How to install standing seam siding.

When used extended drip edge should be installed first along the drip edge of the roof. Install endwall flashing onto zee closures by riveting flashing to top flange of zees at 18 inches on center onto top flange of zee. Standing seam consists of sheet metal roofing panels joined side by side and attached to the roofing. Standing seam integrated thin film solar panels.

The lower end of each panel is then trimmed and the hem pre bent before installation see pg 9. Place sealant over underlap rib before sliding hem over the eave trim. Snap first two to three inches of panel together and slide the panel tight against the eave trim or with the gap depending on the temperature. This video shows how to install box rake trim on standing seam panels.

Unisolar pv panels 136 w 216 each http amzn to 29gz5mt learn how to install metal roof in 15 m. Snap the panels together and fasten along the opposite side and top of the panel. Install zee closures onto panels at both sides. Use endwall flashing to locate correct position of zee closures.

Apply row of tube sealant along back face of zee closure adjacent to panel legs. Fasten with appropriate substrate fastener at minimum 4 fasteners per zee or 3 inches on center.