How To Properly Install Roof Drip Edge

How to install a drip edge.

How to properly install roof drip edge.

The roof leg should extend a minimum of 2 back onto the roof sheathing. How to fix a roof drip edge installing roof drip edge flashing properly. Wrap this around the edge of the eave. It fits perfectly for installation on the eaves.

Apply a continuous bead of cement along the top of the drip edge then press down on the shingle. The drip edge is nailed in place using 1 1 2 galvanized roofing nails. Slide the corner tight to the fascia. On the eaves the peel and stick goes over the drip edge though there is some argument in the industry as whether this is the best way to install drip edge.

Install roof drip edge along the eaves add underlayment then place drip. Make sure the outer edge extends over the gutter. Place a nail at one end then the other. While the vertical leg should be placed 1 4 1 2 away from the fascia.

It is used for mounting on the gable overhang. Once all the underlayment is applied go back and place. To install a drip edge on a newly constructed roof or on a re roofing job attach the drip edge along the roof s eaves first. Using a utility knife cut back the front end of the drip edge.

Be sure to tuck the drip edge under the starter strip and felt paper. A wrapped flap like this is needed to ensure that the drip edge provides comprehensive coverage leaving no room for the water to seep into the roof decking. Secure the drip edge with roofing cement. Slip the wide flat flange of the material all the way under the first course of roof shingles as illustrated.

Make sure the corner is tight and that the bottom edge is tight to the fascia before nailing off the drip edge. Drip edge should be installed on the edge of the roof and should be directed straight down so water can easily be directed into the chute for water. The cutback drip edge will have a bit of an overhang. On the rakes the drip edge goes over the membrane so the roofers apply the membrane first.