How To Remove Roof House Fascia

In most cases you shouldn t have too much trouble getting off the old fascia.

How to remove roof house fascia.

Remove the screws holding it in place and pull the guttering away from the house. This job is easier if you have a helper. Position the ladder against the house under the soffit on level ground. Average cost of soffit and fascia.

Pull the nails with a pry bar to release the gutter straps and lower the gutter. You won t have to remove either the fascia board or the gutter and so you can skip photos 2 and 3. Remove the gutter brackets from your fascia so you can reuse them on the new board. Then locate the brackets underneath your gutter holding them in place and unscrew them so you can lift the gutter up and away from the fascia.

Pry the fascia board off the rafter tails if it shows rot. Use a flat pry bar to remove the damaged fascia board. Lift the roof off the top of the fascia board use your wrecking bar to pry the nails out of the roofing above the rotten piece of fascia. In particular the soffit is located underneath your roof and the fascia is the area directly above it.

Miter the ends of your fascia board to 45 degree angles so they fit together. Unscrew the gutters from behind your existing fascia board with an electric screwdriver. Soffit and fascia are architectural elements of your home which you can find along the eave area or at the edges of your roof. Put on your safety glasses and position the fascia board so the corner on one end lines up with the saw blade.

If so your job is easier. Turn the saw on and pull it down to cut the angle. Buy a new board that matches the old fascia board in both thickness and width. Then lift up the roofing off the board and place a timber block underneath to prop it up.

Ask your helper to hold the bottom of the ladder while you climb up to the soffit. If the board is covered by guttering you will need to carefully remove the gutter first. Work on a section as large as you can reach from the ladder. Remove damaged fascia board.

Concentrate on indented or textured areas that typically hold more dirt trapped in their indentations. Soak a large sponge in the warm water solution and scrub it over the fascia and soffit working back toward the house. You must first disassemble the gutter downspouts unscrew the gutter brackets and remove the gutters from the section. Set the angle of a miter saw to 45 degrees so you can make clean cuts through the board.

They are projected beyond your house s sides or at your roof s overhang.