How To Replace An Awning Motor

This will give you room to work.

How to replace an awning motor.

Unbolt the chain from the drive shaft of the awning motor. If you thought replacing your rv s main patio awning was out of your league as a do it yourselfer watch this first and you just might change your mind. Use high quality heavyweight tight weave vinyl for the best results. How to replace rv awning fabric.

Choose a fabric replacement. Reinstall the gear for the manual handle. Start by measuring your awning from the inside of each cap. Do this on both ends.

We then secured the polly cord with screws to the roller. We used the old awning as our work space to prevent scuffing or damage to the new awning. Refer to the owner s manual as the parts included can be slightly different from manufacture to manufacturer. New motor and wind sensor.

Client on a budget. The steps to replace the rv awning are almost the opposite of the removal. Remove the cap spring. We carefully unfolded located front and back and slid the new rv awning with the attached polly cord into the awning roller.

Use the manual override if the motor is completely. Attach the hardware one by one. Check the manufacturer s instructions for fabric recommendations. Loosen the awning bolts.

Tie the awning arms off to the bracket where it attaches to the side of your rv. Install the motor by sliding it all the way into the end of the roller tube. Install a new motor and tighten the bolts. Replacing the motor on a solara power awning extend your awning about 2 feet.

If this is the case unplug the motor from the electrical source. To do so measure from the center of one arm to the. Afterward head to a home hardware store and purchase an appropriately sized replacement fabric.