How To Secure The Posts On A Gazebo Or Awning

Step 3 using a drill with a 1 2 inch diameter masonry bit slide the bit tip through the ready drilled slot at the bottom of the leg so it rests against the concrete.

How to secure the posts on a gazebo or awning.

Place a level on one leg of the gazebo to make sure it is plumb. Attach 5 8 inch 1 6 cm eyebolts to the caps with nuts and bolts. Use masonry screws and a masonry drill bit to attach the white bases to the bricks. Mar 13 2014 gazebo target worried about your gazebo flying away this summer when that next wind storm happens.

Fill large planters with a layer of sand and a thick layer of concrete. We had a couple of pretty windy days lately and i m happy to report that the gazebo stayed put and the pots look beautiful. Use at least four positioned at the four corners of the canopy. To attach them to the gazebo take a 1 2 inch drill bit to each of the legs to prevent the wood from splitting then place the rods about 10 inches inside the leg and drive the remainder into the ground.

Insert 1 eyebolt into each hole that you drilled. Twist and push tent stakes into the ground. I filled each pot with potting soil then planted pansies in each pot. This will make the white bases and bricks one unit and it should stabilize the gazebo considerably.

Here are the steps involved. Twist some rope around the leg of the canopy to help anchor it. Throw one end of the rope over the horizontal bar that is the edge of the roof. The legs of the gazebo have a little lip on them that is held to the bottom of the pot with the bricks.

If you want to secure your gazebo in windy conditions but you don t want to commit to anchoring it with screws or buying weights you can try securing it in the other ways for example with straps. Do this at the corner. If you have your gazebo on a concrete patio and are not able to secure it into the ground and want to save on the added expense of hiring a professional to come out and drill holes into your. Insert the posts into the concrete while still wet.

Twist a 5 8 inch 1 6 cm nut onto the eyebolt on either side of the cap to sandwich your eyebolt in place a washer on the inside end and then twist a bolt on that end to secure it.