How To Vinyl Siding Starter Strip

This video shows how to install a starter strip for vinyl and polymer siding installation.

How to vinyl siding starter strip.

Measure down from the soffit at one corner of the house to the top of the foundation and subtract 1 4 6 4mm less than the width of the starter strip. Quality products can only perform well if they are installed properly. Position starter strip with the top edge of chalk line and allow room for corner posts. Tahomamaintenanceco march 23 2018 10 58pm 5.

Nail to wall following nailing instructions in important installation tips. Locate the lowest possible corner that has sheathing. Optional method to determining the position of the starter strip in new construction and some re siding applications. Attach one end of the string to the corner of the wall you wish to install a starter strip next hook on the hanging level and walk the string to the other corner now observe the level and adjust the string until it s level.

Snap a level chalk line for the first starter strip at the base of the wall no less than 8 inches above ground level after determining the lowest corner of the house. Pull up as. When the wall surface is uneven shim out the starter strip to avoid a wavy appearance in the finished siding job. Make a mark on the wall and record the measurement.

Measure a spot that is 1 1 2 inches above the bottom edge of the sheathing at this lowest point using a tape. Cap the corner posts. How to replace starter strips for vinyl siding 1. Staret strip secures the first course of siding to the home.

Insert the flat hooked end of the zip tool under the lip on the bottom most edge of the vinyl siding panel that rests. Vinyl siding is no exception. Vinyl siding starter strips. 13 simple vinyl siding installation tips use the wider starter strip.

Secure the end to the house and set the starterstrips against this mark. Cut the new starter strip to size. The bottom of the starter strip the part the bottom panel hooks on to should be at least. This is where the new siding will begin.

How to install a vinyl siding starter strip step 1. Pry off the nails on the nailing flange with a claw hammer to remove the starter strip. This chalk line should be level and a consistent distance from the eaves or the top and bottom of the windows.